Halifax, Sports Car Picnic and New LWT 062

Comment

Comment by Steve Norton on September 4, 2009 at 8:37pm

Paul:
Did this once before on my1970 IIaG. A friend of mine fabricated the entire crossmember, and basically replaced the entire frame aft of the rear axle. The job he did was absolutely first rate. You can order rar frame rails that extend forward from the rear crossmember, so don't dispair. Mostly a lot of dog's work, not terribly expensive. Next time keep the drain holes clear!

Comment by PAUL on September 4, 2009 at 8:25pm

Sounds like the same job we need to do to our Series truck. might need more than the cross member on ours though. The body had had a lot of work done to it before we aquired it and is very presentable. Keep us updated.

Comment by Steve Norton on August 30, 2009 at 9:18pm

Thanks for your kind comments. Gertie is undergoing a well-needed cleanup and replacement of her rear crossmember, and general tiy-up. Will post her again once complete.

Comment by PAUL on August 30, 2009 at 7:38pm

love the lightweight.

Comment by Clarence J Red, III on August 24, 2009 at 9:17pm

She's a beauty!